E3D V6 Hotend for Prusa i3 Mk3s Bear Upgrade
Please note this the hotend which we use in our "Prusa i3 mk3s bear upgrade 3d printers".
This hotend is 100% compatible with "Original Prusa i3 Mk3/S/+ 3d printers. "
You will get all the items as shown in the images.
Please note length of the heater cartridge - apprx 700mm and thermistor wire (700mm) is as per the length which is used in our bear upgrade 3d printer. Similar length of wires is use Original Prusa i3 Mk3/S/+ 3d printer.
Length of the PTFE tube used in the hotend is also as used in our printer.
Please procure this hotend only if you are replacing the hotend of prusa i3 mk3s bear upgrade made by 3dprintronics.
This hotend is provided without any external cooling fan.
We provide this hotend as fully assembled and hot tightened. You do not need to do any hot tightening.
Important point to note :
1) Whenever you change the hotend or nozzle --- do "first layer calibration" after it to set correct gap between nozzle and plate.
You can watch our tutorials given below on how to install the hotend.
After installing the new hotend in your printer. You will have to adjust the PINDA probe height. See the video given below.
Final step is to do - First layer calibration. See the video given below.